95 XFC G4 2103335 Rev AB
5.6 Application Licensing Credit Key
5.6.1 Credit key driver Installation
To install the credit key driver:
Plug the USB credit key into an available USB port.
The Windows
®
operating system will recognize the credit key as new hardware and attempt to install the appropriate
driver with the Found New Hardware Wizard.
Click Next
Point the wizard to the PCCU32 directory.
Select Browse, in the Files Needed screen, and locate the driver usbkey.sys in the PCCU32 directory.
Click on OK, once the driver has been located. Software driver installation will commence.
Click Finish when installation is complete.
The USB credit key is now installed.
IMPORTANT NOTE: If the credit key is inserted in a different USB port on the computer, it will need to be installed
for that new USB port. The credit key must be installed on each available USB port if the same USB port is not
used each time the credit key is used.
5.6.2 Access and view the credit key with PCCU32 7.0 (or later)
To access and view the credit key you must use PCCU32 7.0 (or later). The credit key is a secure device and only accessible
through PCCU32. To view credits on the credit key:
To access and view the credit key:
Install the credit key in an available USB port. For more information about installing the credit key, see section 4.5.1
Credit key driver installation, page 78.
Open PCCU32
Disconnect from the flow computer, if connected.
Click Operate > File Utilities > Credit Key License Utility.
IMPORTANT NOTE: To open the Credit Key License Utility, the PC cannot be connected to the flow computer.
Click Load to view available credits on USB Key (see Figure 74), when the Credit Key Status and Update Utility
screen opens.
To Next Page
Loading...
