210 Agilent Restricted Agilent 5110/5100 ICP-OES Service Manual
7 Service Diagnostics and Fault Finding
Flow chart diagnostics
Flow chart diagnostics
The following diagnostics provide a number of paths to assist in resolving technical issues.
Follow the flow diagram to determine the area of malfunction. Use in conjunction with Software
diagnostics pages.
Failure analysis
i. Failure analysis of software (SW1)
ii. Failure analysis of Plasma (PL1)
iii. Failure analysis of RF (RF1)
iv. Failure analysis of Torch loader (TL1)
v. Failure analysis of Torch compartment (TD1)
vi. Failure analysis of Gas Control system (GC1)
vii. Failure analysis of Peristaltic pump (PC1)
viii. Failure analysis of Water Control system (WC1)
ix. Failure analysis of Pre Optics system (PT1)
x. Failure analysis of Optics system (OP1)
xi. Failure analysis of Camera system (CS1)
xii. Failure analysis of Wavelength Calibration routine (WA1)
xiii. Failure analysis of Thermal Stabilizer (TS1)
xiv. Failure analysis of SSRF water cooling (SWC1)
To Next Page
Loading...
Need help?
General
