276 Agilent Restricted Agilent 5110/5100 ICP-OES Service Manual
10 Installation Guide (5110 ICP-OES)
Polychromator software (PolyAlign.exe)
7 To finish registration click Register.
Polychromator software (PolyAlign.exe)
The Poly Align functions are separate from the main ICP Expert software.
During the installation of the ICP Expert 7 software, the PolyAlign software is automatically
installed.
1 To start the poly Align software, click on the Poly Align short cut located on the ICP Expert 7
program group (Refer to Diagnostics section).
The Poly Align software cannot be run at the same time as the ICP Expert software. Close one
and open the other.
Printer configuration
The printer must be of a model and make supported by Windows. Agilent recommends the use
of the Windows Print manager. Follow the normal Windows printer installation procedures.
1 Click on the start button.
2 Point to settings and click on Devices and printers.
3 Double click on Add Printer.
Follow the instructions on the screen to install the printer driver(s) required. Both network
printers and local printers can be installed with this method.
Windows includes a printer troubleshooter in Help. For more information refer to “print
troubleshooting” in the Windows Help index.
ICP Expert Help system
The ICP Expert Help system contains instructions on how to use the ICP Expert software as well
as step-by-step instructions on how to remove and install the various instrument components.
1 Click on the Windows “Start” button and select Programs ICP Expert Help.
2 When the ICP Expert 7 Help software appears, click on the Hardware link or the How to link.
To Next Page
Loading...
Need help?
General
