To Next Page

To Previous Page

G4208A User’s Guide 104

2 Working with the Instant Pilot

Simultaneous Execution with Software

With Agilent ChemStation

Features

• All user interfaces, the Instant Pilot, the Agilent ChemStation or the Agilent

Cerity WorkStation and OpenLab, can be connected to an Agilent Series

system at the same time.

• Parameter entry is possible from both user interfaces. Parameters are

updated on the other user interface within a few moments.

• An Agilent ChemStation sequence can be stopped and aborted from the

Instant Pilot and vice versa.

• The Agilent ChemStation can generate data files from a Instant Pilot method

or sequence. In this case, the pre- fix and file name counter in the Single

Sample Info section of the Agilent ChemStation must be enabled (protocol

mode only).

• If the Instant Pilot starts an analysis, the Agilent ChemStation is the

slave/monitor system.

• The Agilent or 3rd- party user interface may block certain functionality, e.g.

editing, load, start or others. In such a case, the screen shows a blinking lock-

symbol in the top left.

Restrictions

• If a parameter window is open for parameter entry on the Agilent

ChemStation, this specific entry field is disabled on the Instant Pilot.

• If an analysis is running with the Instant Pilot, the Agilent ChemStation must

not be turned on.

• If the Agilent ChemStation starts an analysis, the Instant Pilot is the

slave/monitor system.

• Parameter changes to a method will be identified on the other user interface

as modification.

• The Instant Pilot and the Agilent ChemStation have a different method

handling (Agilent ChemStation method can have more information than the

method on the Instant Pilot, e.g. additional DAD parameters that are only

Agilent Technologies InfinityLab LC Series User Guide

Other manuals for Agilent Technologies InfinityLab LC Series