G4208A User’s Guide 131
4 Running Multiple-Vial Analyses
Synchronizing Analyses with External Devices
Send Multiple Start Request (external controlled
injector)
This will cause the Instant Pilot to generate start requests before each run. The
external device starts each injection then by sending a start signal to the APG
remote line. That is, after all the programming has been completed on the Instant
Pilot and the Start button has been pressed, a Start Request is issued before
each run and the external device must give the Start command for the injection
process.
Here, too, the module simply tracks the progress of the analysis.
Figure 88 Send multiple external start request
To Next Page
Loading...
Need help?
General
