G4208A User’s Guide 52
1 Start-up Information
Start Analysis Screen
Start Analysis Screen
With firmware revision B.02.01 and A.05.11 (November 2006) the Start Analysis
screen, known from the G1323B Control Module, has been enhanced. It allows to
set up a simple analysis by
• pressing the START key
• adding the vial range and number of injections
• selecting the current or a different method (internal or from USB Flash Drive)
• use of current sequence (if active)
• resume paused sequence
• use Blank Run
• Start from selected line
Figure 33 Analysis Start Screen
leaves this screen
starts the Analysis (when all
modules are ready)
To Next Page
Loading...
