G4208A User’s Guide 11
1 Start-up Information
Requirements for the Instant Pilot
Requirements for the Instant Pilot
The Agilent Instant Pilot can be attached to a modular Agilent HPLC system or a
single Agilent HPLC module. Depending on the system, the following firmware
requirements must be fulfilled.
Table 2 Pre-requisites / Compatibility vs. Modules
Agilent HPLC Modules Instant Pilot Firmware
Revision
A.05.13/14/15
Instant Pilot Firmware
Revision
B.01.02/03/04
Instant Pilot Firmware
Revision B.02.01 and
above
1260/1290 Infinity II Series not compatible not compatible B.02.17 or above
1260 Infinity Series not compatible not compatible B.02.11 or above
1220 Infinty Series LC Systems not compatible not compatible not compatible
1290 Infinity System
• G4212A DAD
• G4220A Binary Pump
• G4226A Autosampler
• G1316C TCC
not compatible not compatible B.02.08 or above
1120 Compact LC not compatible not compatible not compatible
Newer Series 1100/1200 modules that
required special versions of Instant Pilot
• G1315C DAD-SL not compatible B.01.02 or above B.01.02 or above
• G1365C MWD-SL not compatible B.01.02 or above B.01.02 or above
• G1315D DAD not compatible not compatible B.01.02 or above
• G1365D MWD not compatible not compatible B.01.02 or above
• G1314D VWD not compatible not compatible B.01.07 or above
• G1314E VWD SL Plus not compatible not compatible B.01.07 or above
• G1367D ALS SL Plus) not compatible not compatible B.01.07 or above
1100/1200/1260 ChipCube (G4240A) not compatible not compatible not compatible
Series 1200 standard modules (includes all
modules not mentioned below)
A.05.09/10
A.05.11/12/13
A.06.02 or above A.06.02 or above
Series 1100 standard modules (includes all
modules not mentioned below)
A.05.09/10
A.05.11/12/13
A.06.02 or above A.06.02 or above
To Next Page
Loading...
Need help?
General
