Overview
3-4 Defibrillating in AED Mode
The defibrillation process is dependent upon the configuration of your Heart-
stream XL, as described in the following paragraphs.
Defibrillation (using the default configuration)
In its default configuration, the defibrillation process is:
Turn the Energy Select knob to AED On.
)LJXUH(QHUJ\6HOHFW.QRE
The Heartstream XL checks to see if the pads patient cable and multifunction
defib electrodes pads are properly connected. If either connection is compro-
mised, you are prompted to fix the problem.
Analysis begins automatically - there is no need to press
.
Once analysis is complete, the Heartstream XL tells you 6KRFN$GYLVHG
or 1R6KRFN$GYLVH G.
If a shock is advised, press
.
After the first shock is delivered, the Heartstream XL automatically
begins analyzing the ECG and the process repeats until a shock series
is complete or no shock is advised. At this point, you are prompted to
check the patient.
Manual On
AED On
Manual On
AED On
$1$/<=(
6+2&.
To Next Page
Loading...
Need help?
General
