Applying the Sensor
5-6 Monitoring SpO2
Applying the Sensor
Follow the manufacturer’s directions for applying and using the sensor, mak-
ing sure to observe any warnings or cautions. For the best results:
l
Make sure the sensor is dry.
l
If the patient is moving, secure the sensor cable loosely to the patient.
l
Avoid excessive pressure at the sensor site; ensure that circulation is
not obstructed.
l
Keep power cables away from the sensor cable and connection.
l
Avoid placing the sensor in an environment with bright lights (if nec-
essary, cover the sensor with opaque material).
l
Avoid placing the sensor on any extremity with an arterial catheter,
blood pressure cuff, or intravascular venous infusion line.
:$51,1* )DLOXUHWRDSSO\WKHVHQVRUSURSHUO\PD\UHGXFHWKHDFFXUDF\RIWKH6S2
PHDVXU
PHQW
:$51,1* ,QVSHFWWKHVHQVRUDSSOLFDWLRQVLWHDWOHDVWHYHU\WZRKRXUVIRUFKDQJHVLQVNLQTXDO
LW\FRUUHFWRSWLFDODOLJQPHQWDQGSURSHUVHQVRUDSSOLFDWLRQ,IVNLQTXDOLW\LVFRP
SURPLVHGFKDQJHWKHVHQVRUVLWH0RUHIUHTXHQWFKHFNLQJPD\EHUHTXLUHGGXHWRDQ
LQGLYLGXDOSDWLHQW·VFRQGLWLRQ
To Next Page
Loading...
Need help?
General
