Agilent Technologies PSG Series - ΦM Path 1 2; ΦM Rate

Key Reference
Symbols
Chapter 594
ΦM Path 1 2
Supported
PSG-A Series
This softkey toggles the selection between
Φ
M Path 1 and
Φ
M Path 2.
Φ
M Path 1 and
Φ
M Path 2 define two standard phase modulation configurations which can be used
together. Configure the modulation characteristics (such as deviation, source, rate, and
waveform) using the remaining keys in the
Φ
M menu. Then enable
Φ
M by setting
ΦMOffOn to On.
Φ
M Path 1 and
Φ
M Path 2 are summed internally for composite modulation. Either path
can be switched to any one of the modulation sources: Internal 1, Internal 2, Ext1, or
Ext2.
Preset 1
Choices 1 or 2
Location Page 237
Remarks
Φ
M Path 2 must be set to a deviation less than
Φ
M Path 1.
ΦM Rate
Supported
PSG-A Series
This softkey enables you to change the frequency of the currently selected phase
modulation.
Preset 400.0 Hz
Range 0.5 Hz
−
1.0 MHz (Sine)
0.5 Hz
−
100 kHz (other waveforms)
Location Page 237
Remarks None