Agilent Technologies PSG Series - Configuring the LF Output with a Function Generator Source

Fundamental Operation
Configuring the LF Output (PSG-A Series Only)
Chapter 2 43
Configuring the LF Output with a Function Generator Source
In this example, function generator 1 is the LF output source.
Configuring the Function Generator as the LF Output Source
1. Press
Preset.
2. Press the
LF Out hardkey.
3. Press
LF Out Source > Function Generator 1.
Function generator 1 becomes the LF output source and FuncGen 1 is displayed below the
LF Out Source softkey.
Configuring the Waveform
1. Press
LF Out Waveform > Swept-Sine.
This creates a swept-sine output and opens a menu that configures the sweep parameters
of the swept-sine signal.
2. Press
LF Out Start Freq > 100 > Hz.
This sets the swept-sine start frequency to 100 Hz.
3. Press
LF Out Stop Freq > 1 > kHz.
This sets the swept-sine stop frequency to 1 kHz.
4. Press
LF Out Sweep Rate > 350 > Hz.
This sets the swept-sign sweeps-per-second to 350.
5. Press
Return > Return.
This returns you to the LF Output menu. The start frequency for the swept-sine waveform
is displayed below the
LF Out Freq softkey.
Configuring the Low Frequency Output
1. Press
LF Out Amplitude Into 50 Ohms > 3 > Vp.
This sets the LF output amplitude to 3 Vp.
2. Press
LF Out Off On.
This activates the LF output. The LF output is a 3 Vp swept-sine waveform, sweeping from
100 Hz to 1 kHz with a sweep rate of 350 Hz.