Key Reference
S
Chapter 5218
Sweep Type List Step
Supported All
This softkey toggles the sweep type between list sweep and step sweep. You create a list
sweep by supplying the frequency, amplitude, and dwell time for each point in the sweep.
You create a step sweep by supplying the start and stop frequency and amplitude, the
number of points, and a dwell time. The signal generator then calculates the points
between the first and last point in a linear manner.
Preset List
Choices List or step
Location Page 245
Remarks None
Sweep/List
Supported All
Use this hardkey to access a menu of softkeys that enables you to define a series of
points containing frequency, amplitude, and dwell time information for the signal
generator to sweep.
Preset N/A
Range N/A
Location Page 245
Remarks None
To Next Page
Loading...
