Key Reference
R
Chapter 5202
Restore Factory Defaults
Supported PSG-A Series with Option UNJ
This softkey re-sets the bandwidth of the reference oscillator to the factory-defined
default state. The default value for the internal reference bandwidth is 125 Hz. The
default value for the external reference bandwidth is 25 Hz
Preset N/A
Range N/A
Location Page 248
Remarks None.
Return
Supported All
Use this hardkey to move from your current softkey menu to the menu that precedes it
or to cancel an active function entry. When you are at the preset state, the
Return
hardkey has no function.
Preset N/A
Range N/A
Remarks The return key has autorepeat capability. Hold it down and you are
moved repeatedly back through the menus until you either release the
key or you reach the preset state.
RF On/Off
Supported All
This hardkey toggles the operating state of the RF signal at the RF OUTPUT connector.
Although you can configure and engage various modulations, no signal is available at
the RF OUTPUT connector until
RF On/Off is set to On. An annunciator is always turned
on in the display to indicate whether RF is turned on or off.
Preset Off
Range On or Off
Remarks None
To Next Page
Loading...
Need help?
General
