Key Reference
S
Chapter 5 215
Step/Knob Ratio
Supported All
This softkey enables you to set the ratio between the increment value of the step keys
and the front panel knob. For example, if you set the increment value for frequency to
1.0 MHz and set the step/knob ratio to 10/1, when frequency is the active function the up
and down arrow keys will change the frequency in 1.0 MHz steps and the front panel
knob will change the frequency in 1/10th of 1.0 MHz steps.
When you press
Step/Knob Ratio the number displayed in the active entry area
represents the arrow keys step size in the ratio. To enter a new value, rotate the front
panel knob until the desired value is displayed, use the up and down arrow keys, or
enter the value using the numeric keypad and press the
Enter terminator key.
Preset N/A
Range 1
−
10,000
Location Page 248
Remarks This ratio applies only when you have a function active that has an
associated increment value. The step/knob ratio is not affected by a
preset or by a power cycle.
Store to File
Supported All
This softkey accesses a menu that enables you to create a file name and store the current
data to a file in the internal non-volatile memory.
Preset N/A
Range N/A
Location Page 234, Page 246
Remarks The file name can consist of up to 23 alpha-numeric and special
characters.
To Next Page
Loading...
Need help?
General
