Agilent Technologies PSG Series - Select Seq; Self Test; Set ALC Level

Key Reference
S
Chapter 5 211
Select Seq:
Supported All
This softkey enables you to select a sequence for all softkeys which specify a sequence in
this menu. For example, if you want to select sequence 4, press
Select Seq:. The currently
selected sequence is displayed in the active entry area. Change the number to 4 and
press the
Enter terminator softkey. Sequence 4 is now displayed in all softkeys that
specify a sequence in this menu.
Preset 0
Range 0
−
9
Location Page 243, Page 244
Remarks None
Self Test
Supported All
This softkey accesses an automatic, internal diagnostic test that checks for detectable
hardware failures. If there are hardware failures in the signal generator, refer to the
troubleshooting section of the service guide.
Preset N/A
Range N/A
Location Page 250
Remarks This key is intended for use by service personnel.
Set ALC Level
Supported All with Option 1E1
This softkey enables you to change the ALC level. The output power is the ALC level
minus the attenuator setting.
Preset
−
20.00 dBm
Range −20.00 dBm to 25.00 dBm
Location Page 232
Remarks This key is active only when you have toggled the
Atten Hold Off On key
to On.