Key Reference
S
Chapter 5 219
Swept-Sine
Supported PSG-A Series
This softkey enables you to specify a swept sinewave as the modulation waveform for the
internally generated, ac-coupled signal, and displays a menu of choices for setting the
parameters. In this menu you can set the start and stop rate and the sweep time. You
can set the signal generator to a single, externally triggered sweep on either a negative
or positive TTL level or you can choose continuous sweep, triggered immediately. In this
menu you can also select either a positive or negative polarity for the TRIGGER OUT
signal.
Preset N/A
Range N/A
Location Page 230, Page 235, Page 237, Page 240
Remarks Internal 2 is not available for use with the swept-sine function.
To Next Page
Loading...
Need help?
General
