Key Reference
L
Chapter 5 173
LF Out Amplitude Into 50 Ohms
Supported PSG-A Series
This softkey enables you to scale the output of the signal at the LF OUTPUT connector.
Preset 0.0 V
Range 0.0
−
3.5 V
p
Location Page 240
Remarks None
LF Out Freq
Supported PSG-A Series
This softkey enables you to set the modulating frequency for the LF output signal when
you have selected the internal source as a function generator.
Preset 400.0 Hz
Range 0.5 Hz
−
100.0 kHz
0.5 Hz to 1.0 MHz (if sinewave is selected as the internal waveform)
Location Page 240
Remarks This softkey is active only when you have selected the internal source
to operate as a function generator.
LF Out Off On
Supported PSG-A Series
This softkey toggles the operating state of the output of the selected source at the
LF OUTPUT connector. Refer to the ”LF Out Source” softkey in this section for more
information on choosing the source.
Preset Off
Choices Off or On
Location Page 240
Remarks Once you have toggled this state on, the signal is immediately
available at the LF OUTPUT connector. The
RF On/Off hardkey does
not apply to this state.The
Mod On/Off softkey does apply to this state.
To Next Page
Loading...
Need help?
General
