Key Reference
S
Chapter 5212
Set Atten
Supported All with Option 1E1
This softkey enables you to change the amount of attenuation in 5.0 dB steps. The
output power is the ALC level minus the attenuator setting.
Preset 105.00 dB
Range 0.00 dB
−
105.00 dB
Location Page 232
Remarks This key is active only when you have toggled the
Atten Hold Off On key
to On.
Sine
Supported PSG-A Series
This softkey enables you to specify sine as the modulation waveform for the internally
generated, ac-coupled, signal.
Preset N/A
Range N/A
Location Page 230, Page 235, Page 237, Page 240
Remarks The selected waveform applies only to whichever path configuration
you have currently selected.
Single Sweep
Supported All
Use this softkey to arm the sweep. The ARMED annunciator will turn on in the display.
The signal generator will begin the sweep as soon as the sweep trigger is received.
Single Sweep sets the power and the frequency to the first point of the sweep while it is
not initiated or is waiting for the sweep trigger. If you have set the sweep trigger to
Immediate, a sweep is initiated as soon as you arm the sweep.
Preset N/A
Range N/A
Location Page 245
Remarks This key is disabled when
Sweep is set to Off.
To Next Page
Loading...
Need help?
General
