Key Reference
R
Chapter 5204
RS-232 Timeout
Supported All
This softkey enables you to change the value for the RS-232 serial port timeout. If
further input is not received within the assigned timeout period while a SCPI command
is being processed, then the command is aborted and the input buffer is cleared.
Preset N/A
Range N/A
Location Page 248
Remarks Once set, timeout is not affected by a preset or by a power cycle.
Run Complete Self Test
Supported All
Use this softkey to run an automated, internal diagnostic test that checks for detectable
hardware failures. If there are probable hardware failures in the signal generator, refer
to the troubleshooting section of the service guide.
Preset N/A
Range N/A
Location Page 250
Remarks This key is included for use by service personnel.
Run Highlighted Tests
Supported All
This softkey is provided for self test diagnostics. Refer to the troubleshooting section of
the service guide.
Preset N/A
Range N/A
Location Page 250
Remarks This key is included for use by service personnel.
To Next Page
Loading...
Need help?
General
