Key Reference
R
Chapter 5 201
Rename File
Supported All
This softkey enables you to rename the highlighted file in the displayed catalog of files.
When you have entered the new file name, press the
Enter terminator softkey. If you
have changed your mind, press the
Return hardkey. Once you press Enter, the new file is
stored and displayed immediately in the catalog list.
Preset N/A
Range N/A
Location Page 249
Remarks None
Re-SAVE Seq[n] Reg [n]
Supported All
This softkey enables you to save the current instrument state to the selected register
and sequence. If data has already been stored to this location, it will be overwritten. The
signal generator state includes all parameter selections except list sweep data and
selections which are kept as states that are not affected by a preset or a power cycle.
Preset N/A
Range N/A
Location Page 244
Remarks None
Reset RS-232
Supported All
Use this softkey to perform a clean-up on the RS-232 buffer. This clean-up discards any
unprocessed SCPI input received over RS-232 and places the RS-232 connection in a
mode which can detect the optional remote interface.
Preset N/A
Range N/A
Location Page 247
Remarks All other RS-232 communication parameters are unaffected.
To Next Page
Loading...
Need help?
General
