Fundamental Operation
Configuring Analog Modulation (PSG-A Series Only)
Chapter 2 35
Configuring AM
Using this procedure, you will learn how to create a multipath amplitude-modulated RF
carrier with the following characteristics:
• RF output frequency set to 15 GHz
• RF output amplitude set to 0 dBm
• AM Path 1 depth set to 90%
• AM Path 1 rate set to 10 kHz
• AM Path 1 waveform set to sine
• AM Path 2 depth set to 40%
• AM Path 2 waveform set to triangle
Setting the RF Output Frequency
1. Press
Preset.
2. Press
Frequency > 15 > GHz.
The FREQUENCY area of the display now reads 15.000 000 000 00 GHz.
Setting the RF Output Amplitude
Press
Amplitude > 0 > dBm.
The AMPLITUDE area of the display now reads 0.00 dBm.
Setting the AM Depth and Rate
1. Press the
AM hardkey.
The first level menu of softkeys is displayed.
2. Press
AM Depth > 90 > %.
90.0 % is displayed below the
AM Depth softkey.
3. Press
AM Rate > 10 > kHz.
10.0000 kHz is displayed below the
AM Rate softkey.
To Next Page
Loading...
Need help?
General
