Key Reference
P
Chapter 5192
Power On Last Preset
Supported All
This softkey toggles the power-on state of the signal generator between last and preset.
If you choose Last, each time you cycle power to the signal generator it will turn on in
the same condition as when you turned power off.
If you choose Preset, each time you cycle power to the signal generator it will turn on in
either the factory-defined preset condition or in a user-defined preset condition. You
make the choice between factory- and user-defined preset with the
Preset Normal User
softkey.
Preset N/A
Choices Last or Preset
Location Page 247
Remarks If last is active, the signal generator must not receive commands for at
least 3 seconds before the power is turned off to guarantee that the
most recent state is saved.
The power-on state is not affected by a preset or by a power cycle.
Power On/Preset
Supported All
Use this softkey to access a menu of choices for power on and preset conditions. Refer to
“Power On Last Preset” on page 192, “Preset Normal User” on page 194, and
“Save User Preset” on page 207.
Preset N/A
Choices Power On Last Preset Preset Normal User
Save User Preset
Location Page 247
To Next Page
Loading...
Need help?
General
