Key Reference
F
Chapter 5 155
Freq & Ampl
Supported All
Use this softkey to set the signal generator to sweep both frequency and amplitude data.
Preset N/A
Range N/A
Location Page 245
Remarks Both the frequency and the amplitude lists must have the same
number of points or one must have only one point. If a list has only one
point, then that point is used for each of the other list’s points.
Frequency
Supported All
This hardkey enables you to change the RF output frequency. In addition, the key
accesses a menu of softkeys that enables you to configure the reference frequency and
the phase, and specify the oscillator source.
Preset 20.0 GHz or 40.00 GHz (depends on the signal generator)
Range The output frequency range allowed depends on your signal generator
model. Refer to the data sheet.
Location Page 239
Remarks None
Function Generator 1
Supported PSG-A Series
This softkey enables you to select the internal source 1 as a function generator.
Preset N/A
Range N/A
Location Page 240
Remarks When you use the internal source in this capacity, any modulation with
the internal source selected is turned off.
To Next Page
Loading...
Need help?
General
