Key Reference
F
Chapter 5154
Freq Ref Set
Supported All
Use this softkey to set the current output frequency plus the offset frequency as the
frequency reference value. It also causes the
Freq Ref Off On softkey to toggle to the On
position, turning on frequency reference mode. All frequency parameters are then set as
relative to the reference value.
Preset 0.00 Hz
Range 100 kHz
−
highest frequency
Location Page 239
Remarks None
Freq Start
Supported All
This softkey enables you to set the frequency of the first point in the sweep.
Preset Maximum frequency
Range 100 kHz
−
highest frequency
Location Page 233, Page 245
Remarks None
Freq Stop
Supported All
This softkey enables you to set the frequency of the last point in the sweep.
Preset Maximum frequency
Range 100 kHz
−
highest frequency
Location Page 233, Page 245
Remarks None
To Next Page
Loading...
