Key Reference
P
Chapter 5 191
Point Trigger
Supported All
Use this softkey to access a menu of choices that enables you to select a triggering mode
for point-by-point sweep.
Positive
Supported PSG-A Series
This key enables you to select a positively sloped ramp as the modulation waveform for
the internally generated, ac-coupled signal.
Preset N/A
Range N/A
Location Page 230, Page 235, Page 237, Page 240
Remarks None
Power Meter
Supported All
Use this softkey to access a menu of choices that enables you to select the external power
meter model for use during the user flatness calibration.
Preset Free Run
Choices Free Run Trigger Key Bus Ext
Location Page 245
Remarks You can also configure the polarity of the TTL signal output at the
TRIGGER IN connector using the
Trigger In Polarity Neg Pos softkey
on this menu. Refer to “Trigger In Polarity Neg Pos” on page 222.
Preset N/A
Choices E4418B E4419B E4416A E4417A
Location Page 232
Remarks The power meter selection is not affected by a preset or by a power
cycle.
The power meter is controlled only through a GPIB cable.
To Next Page
Loading...
Need help?
General
