Key Reference
L
Chapter 5 179
List
Supported PSG-A Series
This softkey enables you to specify that only list sweep files be included in the catalog of
files currently displayed.
Preset N/A
Range N/A
Location Page 249
Remarks None
Load Cal Array From Step Array
Supported All
This softkey enables you to set up a table that includes the start frequency, stop
frequency, and number of points that are defined in the Configure User Flatness Step
Array menu.
Preset N/A
Range N/A
Location Page 233
Remarks None
Load From Selected File
Supported All
This softkey enables you to load the list sweep data from a file into the current sweep
list. Use the arrow hardkeys to highlight the desired sweep list file. Press
Load From Selected File and the list sweep data from the selected file is loaded into the
current list sweep. You can only have one list sweep at a time so the existing list sweep
data will be lost unless it is first stored to a file.
Preset N/A
Range N/A
Location Page 234, Page 246
Remarks This key is inactive unless at least one list sweep data file has been
stored to memory.
To Next Page
Loading...
Need help?
General
