Fundamental Operation
Configuring the RF Output
Chapter 228
9. Highlight the frequency item for point 8, then press
Insert Item.
Pressing
Insert Item shifts frequency values down one row, beginning at point 8. Note that
the original frequency values for both points 8 and 9 shift down one row, creating an entry
for point 10 that contains only a frequency value (the power and dwell time items do not
shift down).
The frequency for point 8 is still active.
10.Press
590 > MHz.
11. Press
Insert Item >
−
2.5 > dBm.
This inserts a new power value at point 8 and shifts down the original power values for
points 8 and 9 by one row.
12.Highlight the dwell time for point 9, then press
Insert Item.
A duplicate of the highlighted dwell time is inserted for point 9, shifting the existing value
down to complete the entry for point 10.
Activating List Sweep for a Single Sweep
1. Press
Return > Sweep > Freq & Ampl
This turns the sweep on again. No errors should occur if all parameters for every point
have been defined in the previous editing process.
2. Press
Single Sweep.
The signal generator will sweep the points in your list once. The SWEEP annunciator is
activated during the sweep.
3. Press
More (1 of 2) > Sweep Trigger > Trigger Key.
This sets the sweep trigger to occur when you press the
Trigger hardkey.
4. Press
More (2 of 2) > Single Sweep.
This arms the sweep. The ARMED annunciator has activated.
5. Press the
Trigger hardkey.
The signal generator will sweep the points in your list once and the SWEEP annunciator is
activated during the sweep.
To Next Page
Loading...
Need help?
General
