Alcatel-Lucent 7210 SAS M - Configuring a VLL Service with CLI

Virtual Leased Line Services
7210 SAS M Services Guide Page 171
Configuring a VLL Service with CLI
This section provides information to configure Virtual Leased Line (VLL) services using the
command line interface.
Topics in this section include:
• Basic Configurations on page 172
• Common Configuration Tasks on page 172
→ Configuring VLL Components on page 173
− Creating a Cpipe Service on page 174
− Creating an Epipe Service in Network Mode on page 180
− Using Spoke SDP Control Words on page 192
• Service Management Tasks on page 196
Cpipe
→ Modifying a Cpipe Service on page 197
→ Deleting a Cpipe Service on page 198
Epipe:
→ Modifying Epipe Service Parameters on page 199
→ Disabling an Epipe Service on page 199
→ Re-Enabling an Epipe Service on page 200
→ Deleting an Epipe Service on page 200