Alcatel-Lucent 7210 SAS M - VPLS Clear Commands

Show, Clear, Debug Commands
Page 930 7210 SAS M Services Guide
VPLS Clear Commands
id
Syntax id service-id
Context clear>service
clear>service>statistics
Description This command clears commands for a specific service.
Parameters service-id — The ID that uniquely identifies a service.
Values service-id: 1 — 214748364
svc-name: A string up to 64 characters in length.
statistics
Syntax statistics
Context clear>service>stats
Description This command clears session statistics for this service.
fdb
Syntax fdb {all | mac ieee-address | sap sap-id] | mesh-sdp sdp-id[:vc-id] | spoke-sdp sdp-id:vc-
id}
Context clear>service>id
Description This command clears FDB entries for the service.
Parameters all — Clears all FDB entries.
mac ieee-address — Clears only FDB entries in the FDB table with the specified 48-bit MAC
address. The MAC address can be expressed in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff
where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
mesh-sdp — Clears only service FDB entries associated with the specified mesh SDP ID. For a mesh
SDP, the VC ID is optional.
spoke-sdp — Clears only service FDB entries associated with the specified spoke SDP ID. For a
spoke SDP, the VC ID must be specified.
sdp-id — The SDP ID for which to clear associated FDB entries.