EasyManua.ls Logo

Alcatel-Lucent 7210 SAS M - LAG Port Membership Constraints; VPLS Feature Support and Restrictions

Alcatel-Lucent 7210 SAS M
952 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Virtual Private LAN Services
7210 SAS M Services Guide Page 299
LAG Port Membership Constraints
If a LAG has a non-supported port type as a member, a SAP for the routing-enabled VPLS service
cannot be created on the LAG. Once one or more routing enabled VPLS SAPs are associated with
a LAG, a non-supported Ethernet port type cannot be added to the LAG membership.
VPLS Feature Support and Restrictions
When the allow-ip-int-binding flag is set on a VPLS service, the following features cannot be
enabled (The flag also cannot be enabled while any of these features are applied to the VPLS
service.):
SDPs used in spoke or mesh SDP bindings cannot be configured.
The VPLS service type cannot be a M-VPLS.
MVR from Routed VPLS and to another SAP is not supported.
Default QinQ SAPs is not supported in R-VPLS service.
The “allow-ip-int-binding” command cannot be used in a VPLS service which is acting as
the G8032 control instance.
IPv4 filters (ingress and egress) can be used with the R-VPLS SAPs. Additionally IP
ingress override filters are supported which affects the behavior of the IP filters attached
to the R-VPLS SAPs. Please see below for more information about use of ingress override
filters.
MAC filters (ingress and egress) are not supported for use with R-VPLS SAPs.
VPLS IP interface is not allowed in a R-VPLS service. The converse also holds.
VPLS service can use either access SAP or Access-Uplink SAPs.
VPLS service can use the following 'svc-sap-type' values: any, dot1q-preserve and null-
star. Only specific SAP combinations are allowed for a given svc-sap-type, except that
default QinQ SAPs cannot be used in a R-VPLS service. The allowed SAP combinations
are similar to that available in a plain VPLS service and is as given in the table above in
the services Chapter (with the exception noted before).
G8032 or mVPLS/STP based protection mechanism can be used with R-VPLS service. A
separate G8032 control instance or a separate mVPLS/STP instance needs to be used and
the R-VPLS SAPs needs to be associated with these control instances such that the R-
VPLS SAP's forwarding state is driven by the control instance protocols.
IGMP snooping is not supported in a VPLS service.

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Related product manuals