Alcatel-Lucent 7210 SAS M - VPRN Debug Commands

Show, Clear, Debug Commands
Page 796 7210-SAS M Services Guide
VPRN Debug Commands
id
Syntax [no] id service-id
Context debug>service
Description This command debugs commands for a specific service.
The no form of the command disables debugging.
Parameters service-id — The ID that uniquely identifies a service.
sap
Syntax [no] sap sap-id
Context debug>service>id
Description This command displays Subscriber Host Connectivity Verification (SHCV) events for a particular
SAP.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
sap
Syntax [no] sap sap-id
Context debug>service>id
debug>service>stp
Description This command enables STP debugging for a specific SAP.
The no form of the command disables debugging.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
sdp
Syntax [no] sdp sdp-id:vc-id
Context debug>service>id
Description This command enables STP debugging for a specific SDP.