Virtual Private Routed Network Services
7210 SAS M Services Guide Page 635
PIM Commands
pim
Syntax [no] pim
Context config>service>vprn
Description This command configures a Protocol Independent Multicast (PIM) instance in the VPRN service.
When an PIM instance is created, the protocol is enabled. PIM is used for multicast routing within the
network. Devices in the network can receive the multicast feed requested and non-participating
routers can be pruned. The supports PIM sparse mode (PIM-SM).
The no form of the command deletes the PIM protocol instance removing all associated configuration
parameters.
Default none
apply-to
Syntax apply-to {all | none}
Context config>service>vprn>pim
Description This command creates a PIM interface with default parameters.
If a manually created interface or modified interface is deleted, the interface will be recreated when
the apply-to command is executed. If PIM is not required on a specific interface, then execute a
shutdown command.
The apply-to command is saved first in the PIM configuration structure, all subsequent commands
either create new structures or modify the defaults as created by the apply-to command.
Default none (keyword)
Parameters all — Specifies that all VPRN and non-VPRN interfaces are automatically applied in PIM.
none — No interfaces are automatically applied in PIM. PIM interfaces must be manually
configured.
To Next Page
Loading...
Need help?
General
