Alcatel-Lucent 7210 SAS M Service Guide

Show, Clear, Debug Commands
Page 792 7210-SAS M Services Guide
VPRN Clear Commands
arp-host
Syntax arp-host
arp-host { mac ieee-address | sap sap-id | ip-address ip-address[/mask] }
arp-host [port port-id] [inter-dest-id intermediate-destination-id | no-inter-dest-id]
arp-host statistics [sap sap-id | interface interface-name]
Context clear>service>id
Description This command clears ARP host data.
forwarding-table
Syntax forwarding-table [slot-number]
Context clear>router
Description This command clears the route table on the specified IOM with the route table.
If the slot number is not specified, the command forces the route table to be recalculated.
Parameters slot-number — Clears the specified IOM slot.
Default all IOMs
Values 1 - 10 (depending on chassis model)
interface
Syntax interface [ip-int-name | ip-addr] [icmp]
Context clear>router
Description This command clears IP interface statistics.
If no IP interface is specified either by IP interface name or IP address, the command will perform the
clear operation on all IP interfaces.
Parameters ip-int-name | ip-addr — The IP interface name or IP interface address.
Default All IP interfaces.
icmp — Specifies to reset the ICMP statistics for the IP interface(s) used for ICMP rate limit.
damping
Syntax damping [[ip-prefix/mask] [neighbor ip-address]] | [group name]

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English