Alcatel-Lucent 7210 SAS M - MC-LAG Multihoming for Native PBB

Virtual Private LAN Services
7210 SAS M Services Guide Page 455
MC-LAG Multihoming for Native PBB
This section describes a configuration example for BEB C configuration given the following
assumptions:
• BEB C and BEB D are MC-LAG peers
• B-VPLS 100 on BEB C and BEB D
• VPLS 1000 on BEB C and BEB D
• MC-LAG 1 on BEB C and BEB D
CLI Syntax:
service pbb
source-bmac ab-ac-ad-ef-00-00
port 1/1/1
ethernet
encap-type qinq
lag 1
port 1/1/1 priority 20
lacp active administrative-key 32768
redundancy
multi-chassis
peer 1.1.1.3 create
source-address 1.1.1.1
mc-lag
lag 1 lacp-key 1 system-id 00:00:00:01:01:01
system-priority 100
source-bmac-lsb use-lacp-key
service vpls 100 bvpls
sap 2/2/2:100 // bvid 100
mac-notification
no shutdown
service vpls 101 bvpls
sap 2/2/2:101 // bvid 101
mac-notification
no shutdown
// no per BVPLS source-bmac configuration, the chassis one (ab-ac-ad-ef-
00-00) is used
service vpls 1000 ivpls
backbone-vpls 100
sap lag-1:1000 //automatically associates the SAP with ab-ac-ad-
ef-00-01 (first 36 bits from BVPLS 100 sbmac+16bit source-bmac-
lsb)