Alcatel-Lucent 7210 SAS M - Global Services Command Reference

Subscriber Services
7210 SAS M Services Guide Page 89
Global Services Command Reference
Command Hierarchies
• Customer Commands on page 89
• Pseudowire (PW) Commands (applicable only for 7210 SAS-M network mode) on
page 89
• SDP Commands (Applicable only to 7210 SAS-M in network mode) on page 91
• SAP Commands for 7210 SAS-M in Network mode on page 91
• ETH-CFM Configuration Commands on page 93
• SAP Commands for 7210 SAS-M in Access-uplink mode on page 92
• Show Commands on page 94
NOTE: All the CLI commands are not available in both access-uplink mode and network
modes. Commands applicable to each mode is called out explicitly.
Customer Commands
config
—service
— [no] customer customer-id
— contact contact-information
—no contact
— description description-string
—no description
— [no] phone phone-number
Pseudowire (PW) Commands (applicable only for 7210 SAS-M network mode)
config
—service
—[no] pw-template policy-id [use-provisioned-sdp] [create]
— accounting-policy acct-policy-id
—no accounting-policy
—[no] collect-stats
—[no] control-word
—[no] disable-learning
—[no] disable-aging
—[no] discard-unknown-source
— limit-mac-move {blockable|non-blockable}
—no limit-mac-move
—[no] vc-type