Alcatel-Lucent 7210 SAS M Service Guide

Support for processing of packets received with more than 2 tags on a QinQ SAP in Epipe service (only
Page 140 7210 SAS M Services Guide
• OAM tools
→ MPLS OAM tools such as vccv-ping, vccv-trace, etc. is supported for the SDPs
→ Accounting and Statistics for the service entities (e.g. SAP and SDP) will be available
as before
→ CFM is not supported.
• Following Redundancy mechanisms available in Epipe service is supported when using
MPLS SDP:
→ Epipe PW redundancy
→ MC-LAG based protection for access SAPs using the new service type (along with
use PW redundancy)
Configuration of Epipe service for processing of packets received with more
than 2 tags on a QinQ SAP (only on 7210 SAS-M network mode)
The following is the example when the user configures “vlan-vc-tag” value to match the inner tag
specified in the Q1.Q2 SAP configured in the service :
*A:7210SAS>config>service# info
----------------------------------------------
epipe 10 svc-sap-type qinq-inner-tag-preserve customer 1 create
sap 1/1/3:10.45 create
exit
spoke-sdp 111:69 vc-type vlan create
vlan-vc-tag 45
exit
no shutdown
----------------------------------------------
The following is the example of an Epipe service with QinQ SAP and dot1q SAP. In the example
below, note that the Dot1q SAP's (1/1/4:45) VLAN value '45', matches the inner tag VLAN value
specified with QinQ SAP (1/1/3:10.45).
*A:7210>config>service# info
----------------------------------------------
epipe 10 svc-sap-type qinq-inner-tag-preserve customer 1 create
sap 1/1/3:10.45 create
no shutdown
exit
sap 1/1/4:45 create
no shutdown
exit
no shutdown
exit
----------------------------------------------

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English