Alcatel-Lucent 7210 SAS M - VLL Clear Commands

VLL Clear Commands
7210 SAS M Services Guide Page 855
VLL Clear Commands
id
Syntax id service-id
Context clear>service
clear>service>statistics
Description This command clears commands for a specific service.
Parameters service-id — The ID that uniquely identifies a service.
Values service-id: 1 — 214748364
svc-name: A string up to 64 characters in length.
spoke-sdp
Note : SDP commands are not supported by 7210 SAS-M devices configured in Access uplink mode.
Syntax spoke-sdp sdp-id:vc-id ingress-vc-label
Context clear>service>id
Description This command clears and resets the spoke SDP bindings for the service.
Parameters sdp-id — The spoke SDP ID to be reset.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be reset.
Values 1 — 4294967295
ingress-vc-label — Specifies to clear the ingress VC label.
sap
Syntax sap sap-id {all | counters | stp}
Context clear>service>statistics
Description This command clears SAP statistics for a SAP.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
all — Clears all SAP queue statistics and STP statistics.
counters — Clears all queue statistics associated with the SAP.
stp — Clears all STP statistics associated with the SAP.