Configuration Notes
Page 64 7210 SAS M Services Guide
Configuration Notes
This section describes service configuration caveats.
General
Service provisioning tasks can be logically separated into two main functional areas, core tasks
and subscriber tasks and are typically performed prior to provisioning a subscriber service.
Core tasks include the following:
• Create customer accounts
• Create template QoS, filter, scheduler, and accounting policies
• Create SDPs (Not applicable for 7210 SAS-M devices configured in Access Uplink mode)
Subscriber services tasks include the following:
• Create Epipe and VPLS services.
• Create a VPRN service (Supported only in 7210 SAS-M network mode)
• Bind SDPs (Not applicable for 7210 SAS-M devices configured in Access Uplink mode)
• Configure interfaces (where required) and SAPs
• Create exclusive QoS and filter policies
To send and receive inband management traffic (for 7210 SAS-M in configured in access uplink
mode), create an IES service.
To Next Page
Loading...
