Configuring a VLL Service with CLI
Page 172 7210 SAS M Services Guide
Basic Configurations
• Creating a Cpipe Service on page 174
• Creating an Epipe Service in Network Mode on page 180
• Using Spoke SDP Control Words on page 192
• Configuring VLL Resilience on page 193
Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed to configure the VLL
services and provides the CLI commands.
• Associate the service with a customer ID.
• Define SAP parameters
→ Optional - select ingress QoS policies (configured in the config>qos context).
→ Optional - select accounting policy (configured in the config>log context).
• Define spoke SDP parameters (Not applicable for 7210 SAS-M devices configured in
Access Uplink mode).
• Enable the service.
To Next Page
Loading...
