Alcatel-Lucent 7210 SAS M - Creating an Epipe Service for 7210 SAS-M with Range Saps

Configuring a VLL Service with CLI
Page 182 7210 SAS M Services Guide
Local Epipe SAPs
To configure a basic local Epipe service, enter the sap sap-id command twice with different port
IDs in the same service configuration.
By default, QoS policy ID 1 is applied to ingress service SAPS. Existing filter policies or other
existing QoS policies can be associated with service SAPs on ingress and egress ports.
Ingress and Egress SAP parameters can be applied to local and distributed Epipe service SAPs.
This example displays the SAP configurations for local Epipe service 500 on SAP 1/1/2 and SAP
1/1/3 on ALA-1.
A:ALA-1>config>service# epipe 500 customer 5 create
config>service>epipe$ description "Local epipe service
config>service>epipe# sap 1/1/2 create
config>service>epipe>sap? ingress
config>service>epipe>sap>ingress# qos 20
config>service>epipe>sap>ingress# filter ip 1
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# egress
config>service>epipe# sap 1/1/3 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# qos 555
config>service>epipe>sap>ingress# filter ip 1
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# no shutdown
config>service>epipe>sap# exit
A:ALA-1>config>service# info
----------------------------------------------
...
epipe 500 customer 5 create
description "Local epipe service"
sap 1/1/2 create
ingress
qos 20
filter ip 1
exit
exit
sap 1/1/3 create
ingress
qos 555
filter ip 1
exit
exit
no shutdown
exit
----------------------------------------------
A:ALA-1>config>service#
Creating an Epipe Service for 7210 SAS-M with range SAPs
The following displays an example of connection-profile used to configure a range of SAPs and an
Epipe configuration using the connection profile:
*A:7210SAS>config>connprof# info