Configuring an IES Service with CLI
Page 508 7210-SAS M Services Guide
Basic Configuration
The most basic IES service configuration has the following entities:
• Customer ID (refer to Configuring Customers on page 69)
• An interface to create and maintain IP routing interfaces within IES service ID.
• A SAP on the interface specifying the access port and encapsulation values.
The following example displays a sample configuration of an IES service on ALA-48 on an
access-uplink SAP (applicable for access-uplink mode only).
*A:ALA-48>config>service# info
----------------------------------------------
ies 1000 customer 50 create
description "to internet"
interface "to-web" create
address 10.1.1.1/24
sap 1/1/5:0.* create
exit
exit
no shutdown
----------------------------------------------
*A:ALA-48>config>service#
The following example displays a basic IES service configuration for Ipv6, along with the use of
max-ipv6-routes in 7210 SAS-M access-uplink mode:
The following displays an example of allocation of IPv6 routes on the node:
*A:7210SAS>config>system>res-prof# info
----------------------------------------------
max-ipv6-routes 1000
----------------------------------------------
NOTE: the node must be rebooted after the above change.
*A:ALA-50>config>service# info
----------------------------------------------
ies 1000 customer 50 vpn 1000 create
description "to inband-mgmt"
interface "to-mgmt" create
ipv6
address 10::1/24
sap 1/1/10:100.* create
exit
exit
no shutdown
----------------------------------------------
*A:ALA-50>config>service#
The following example displays a sample configuration of an IES service on ALA-50.
*A:ALA-50>config>service# info
----------------------------------------------
To Next Page
Loading...
