Services
7210 SAS M Services Guide Page 61
Configuration guidelines for G.8032
For 7210 SAS-M devices in network mode, to improve service fail-over time due to failures in the
ring path, users can use the CLI command config> system>resourceprofile>g8032-fast-flood-
enable. When fast flood is enabled, on a failure detection in one of the paths of the eth-ring, along
with MAC flush the system starts to flood the traffic onto the available path. The resources needed
for this functionality are shared with filters and affects filter scaling. For more information refer to
the command description of the command g8032-fast-flood-enable in the 7210 SAS-M,X
Interface configuration guidefor more details.
For 7210 SAS-M devices in access-uplink mode, to
improve the service fail-over time due to failures in the ring path, fast flood is enabled by default.
On a failure detection in one of the paths of the eth-ring, along with MAC flush the system starts
to flood the traffic onto the available path. No explicit user configuration is needed for this and it
does not affectscaling for filters.
• Down MEPs used with services and G.8032 share common hardware resources.
• Service level MEPs are not available on all SAPs tied to an eth-ring instance on a port.
To Next Page
Loading...
Need help?
General
