Alcatel-Lucent 7210 SAS M Service Guide

Configuring a VLL Service with CLI
Page 200 7210 SAS M Services Guide
Re-Enabling an Epipe Service
To re-enable an Epipe service that was shut down.
CLI Syntax: config>service# epipe service-id
no shutdown
Example:config>service# epipe 2
config>service>epipe# no shutdown
config>service>epipe# exit
Deleting an Epipe Service
Perform the following steps prior to deleting an Epipe service:
1. Shut down the SAP.
2. Delete the SAP.
3. Shut down the service.
Use the following CLI syntax to delete an Epipe service:
CLI Syntax: config>service
[no] epipe service-id
shutdown
[no] sap sap-id
shutdown
Example
:config>service# epipe 2
config>service>epipe# sap 1/1/3:21
config>service>epipe>sap# shutdown
config>service>epipe>sap# exit
config>service>epipe# no sap 1/1/3:21
config>service>epipe# epipe 2
config>service>epipe# shutdown
config>service>epipe# exit
config>service# no epipe 2

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English