Alcatel-Lucent 7210 SAS M - Basic Configuration

Basic Configuration
Page 66 7210 SAS M Services Guide
Basic Configuration
The most basic service configuration must have the following:
• A customer ID
• A service type
• A service ID
• A SAP identifying a port and encapsulation value
• For distributed services: an associated SDP (Not applicable for 7210 SAS-M devices
configured in Access Uplink mode)
The following example provides an Epipe service configuration displaying the SDP and Epipe
service entities. SDP ID 1 was created with the far-end node 10.20.1.2. Epipe ID 101 was created
for customer ID 1 which uses the SDP ID 1.
A:ALA-7210M>config>service#
------------------------------------------
...
sdp 1 mpls create
description "Default sdp description"
far-end 10.20.1.2
lsp "lsp_1_to_B"
signaling tldp
no vlan-vc-etype
path-mtu 9194
no adv-mtu-override
keep-alive
shutdown
hello-time 10
hold-down-time 10
max-drop-count 3
timeout 5
no message-length
exit
no collect-stats
no accounting-policy
no shutdown
exit
...
epipe 101 customer 1 vpn 101 create
description "Default epipe description for service id 101"
service-mtu 9194
sap lag-2:101 create
description "Default sap description for service id 101"
no tod-suite
dot1ag
exit
ingress
qos 1
no filter
exit
spoke-sdp 101:101 vc-type ether create