VPRN Show Commands
7210-SAS M Services Guide Page 719
VPRN Show Commands
VPRN
egress-label
Syntax egress-label start-label [end-label]
Context show>service
Description Display services using the range of egress labels.
If only the mandatory start-label parameter is specified, only services using the specified label are
displayed.
If both start-label and end-label parameters are specified, the services using the range of labels X
where start-label <= X <= end-label are displayed.
Use the show router ldp bindings command to display dynamic labels.
Parameters start-label — The starting egress label value for which to display services using the label range. If
only egress-label1 is specified, services only using egress-label1 are displayed.
Values 0 | 2048 — 131071
end-label — The ending egress label value for which to display services using the label range.
Default The egress-label1 value.
Values 2049 — 131071
Output Show Service Egress Command Output — The following table describes show service
egress label output fields.
Label Description
Svc Id The ID that identifies a service.
Sdp Id The ID that identifies an SDP.
Type Indicates whether the SDP binding is a spoke or a mesh.
I. Lbl The VC label used by the far-end device to send packets to this device
in this service by the SDP.
E. Lbl The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Number of bindings
found
The total number of SDP bindings that exist within the specified egress
label range.
To Next Page
Loading...
Need help?
General
