Show, Clear, Debug Commands
Page 720 7210-SAS M Services Guide
Sample Output
*A:ALA-12# show service egress-label 0 10000
==============================================================================
Martini Service Labels
==============================================================================
Svc Id Sdp Id Type I.Lbl E.Lbl
------------------------------------------------------------------------------
1 10:1 Mesh 0 0
1 20:1 Mesh 0 0
1 30:1 Mesh 0 0
1 100:1 Mesh 0 0
...
1 107:1 Mesh 0 0
1 108:1 Mesh 0 0
1 300:1 Mesh 0 0
1 301:1 Mesh 0 0
1 302:1 Mesh 0 0
1 400:1 Mesh 0 0
1 500:2 Spok 131070 2001
1 501:1 Mesh 131069 2000
100 300:100 Spok 0 0
200 301:200 Spok 0 0
300 302:300 Spok 0 0
400 400:400 Spok 0 0
------------------------------------------------------------------------------
Number of Bindings Found : 23
==============================================================================
*A:ALA-12#
ingress-label
Syntax ingress-label start-label [end-label]
Context show>service
Description Display services using the range of ingress labels.
If only the mandatory start-label parameter is specified, only services using the specified label are
displayed.
If both start-label and
end-label parameters are specified, the services using the range of labels X
where start-label <= X <= end-label are displayed.
Use the show router vprn-service-id ldp bindings command to display dynamic labels.
Parameters start-label — The starting ingress label value for which to display services using the label range. If
only start-label is specified, services only using start-label are displayed.
Values 0, 2048 — 131071
end-label — The ending ingress label value for which to display services using the label range.
Default The start-label value.
Values 2048 — 131071
Output Show Service Ingress-Label — The following table describes show service ingress-label output
fields:
To Next Page
Loading...
