Alcatel-Lucent 7210 SAS M - Configuration Guidelines

Interface Configuration
7210 SAS M Services Guide Page 943
Configuration Guidelines
The following configuration guidelines must be followed to configure a split horizon group.
1. Create a split horizon group in the config prompt. The group name must be unique across
the system.
7210-SAS1>config#info
#--------------------------------------------------
echo "Split-horizon-group Configuration"
#--------------------------------------------------
split-horizon-group access create
description “Block access between access Ports”
split-horizon-group network create
description "Block access between network Ports"
exit
#--------------------------------------------------
7210-SAS1>config#
2. Configure ports 1/1/4 and 1/1/5 as access ports and associate these ports with split
horizon group “access”.
7210-SAS1>config#info
#--------------------------------------------------
echo "Port Configuration"
#--------------------------------------------------
port 1/1/4
split-horizon-group access
ethernet
mode access
access
exit
exit
no shutdown
exit
port 1/1/5
split-horizon-group access
ethernet
mode access
access
exit
exit
no shutdown
exit
#--------------------------------------------------
7210-SAS1>config#
3. Configure ports 1/1/1 and 1/1/3 as network ports and associate these ports with split
horizon group “network”. The default Ethernet encapsulation for network port is null.