Alcatel-Lucent 7210 SAS M - VLL Show Commands

VLL Show Commands
7210 SAS M Services Guide Page 801
VLL Show Commands
VLL
sap-using
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [ingress | egress] qos-policy qos-policy-id
sap-using encap-type encap-type
Context show>service
Description This command displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters ip-addr — The IP address of the interface for which to display matching SAPs.
Values 1.0.0.0 to 223.255.255.255
ip-int-name — Specifies the IP interface name for which to display matching SAPs.
ingress — Specifies matching an ingress policy.
ingress — Specifies matching an ingress policy.
ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress QoS Policy ID for which to display matching SAPs.
Values 1 — 65535
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
sap sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
encap-type encap-type — Displays the CEM encapsulation type.
Values cem
Output Show Service SAP — The following table describes show service SAP output fields:
Label Description
Port ID
The ID of the access port where the SAP is defined.
Svc ID
The service identifier.
MTU
The port MTU value.