IES Show Commands
7210-SAS M Services Guide Page 699
IES Show Commands
IES
customer
Syntax customer [customer-id] [site customer-site-name]
Context show>service
Description This command displays service customer information.
Parameters customer-id — Displays only information for the specified customer ID.
Default All customer IDs display
Values 1 — 2147483647
site customer-site-name — Specifies the customer site which is an anchor point for an ingress and
egress virtual scheduler hierarchy.
Output Show Customer Command Output — The following table describes show customer command
output fields:
Label Description
Customer-ID
The ID that uniquely identifies a customer.
Contact
The name of the primary contact person.
Description
Generic information about the customer.
Phone
The phone/pager number to reach the primary contact person.
Total Customers
The total number of customers configured.
Multi-service site
Site
Multi-service site name. A multi-service customer site is a group of
SAPs with common origination and termination points.
Description
Information about a specific customer's multi-service site.
Assignment
The port ID, MDA, or card number, where the SAP's that are members
of this multi- service site are defined.
I. Sched Pol
The ingress QoS scheduler policy assigned to this multi-service site.
E. Sched Pol
The egress QoS scheduler policy assigned to this multi-service site.
Service Association
Service-ID
The ID that uniquely identifies a service.
SAP
Specifies the SAP assigned to the service.
To Next Page
Loading...
