Alcatel-Lucent 7210 SAS M - Configuring IES Interface Parameters

Configuring an IES Service with CLI
Page 512 7210-SAS M Services Guide
Configuring IES Interface Parameters
in network mode*A:7210-SAS>config>service>ies>if# info
----------------------------------------------
arp-timeout 10000
allow-directed-broadcasts
icmp
ttl-expired 120 38
exit
arp-populate
ip-mtu 1000
host-connectivity-verify interval 500 timeout 50 retry-count 15
delayed-enable 150
bfd 150 receive 300 multiplier 15 echo-receive 3000
local-proxy-arp
remote-proxy-arp
loopback
*A:7210-SAS>config>service>ies>if#
----------------------------------------------
The following example displays an IES configuration with interface parameters in access-uplink
mode:
*A:7210-SAS>config>service>ies>if# info
----------------------------------------------
arp-timeout 10000
allow-directed-broadcasts
icmp
ttl-expired 120 38
exit
ip-mtu 1000
----------------------------------------------
*A:7210-SAS>config>service>ies>if#